Using third-party aircrafts

737-800 NGX from PMDG for MSFSX/P3D
737-800 NGXu from PMDG for MSFS 2020
737-800 NGXu from PMDG for Prepar3D

Important information when working with Prepar3D or Microsoft Flight Simulator 2020

You must select the correct Simulation in CLS2Sim when using any of the supported third-party aircrafts!
You can connect to Prepar3D even if you have MSFS2020 selected as sim in CLS2Sim, however the planes will not function correctly!

737-800 NGX from PMDG

After installing the aircraft, run the simulation and start a flight with the plane until you are in the cockpit.
This is needed so the plane can genereate it's settings files.

Close the sim, then go to the Microsoft Flight Simulator installation directory.

Open PMDG\PMDG 737 NGX\737NGX_Options.ini and add the following two lines, if they don't already exist.
Make sure there is an empty line after EnableDataBroadcast=1, or sim software will delete your setting again!

[SDK]
EnableDataBroadcast=1

737-800 NGXu from PMDG for MS FS 2020

After installing the aircraft, run the simulation and start a flight with the plane until you are in the cockpit.
This is needed so the plane can genereate it's settings files.

Close the sim, then go to the following directory (enter address in File Explorer)
%LOCALAPPDATA%\Packages\Microsoft.FlightSimulator_8wekyb3d8bbwe\LocalState\packages\pmdg-aircraft-736\work\

Open 737_Options.ini and add the following two lines, if they don't already exist.
Make sure there is an empty line after EnableDataBroadcast=1, or the sim software will delete your setting again!

[SDK]
EnableDataBroadcast=1

737-800 NGXu from PMDG for Prepar3D v5

After installing the aircraft, run the simulation and start a flight with the plane until you are in the cockpit.
This is needed so the plane can genereate it's settings files.

Close the sim, then go to the Prepar3D installation directory.

Open PMDG\PMDG 737 NGXu\737NGXu_Options.ini and add the following two lines, if they don't already exist.
Make sure there is an empty line after EnableDataBroadcast=1, or sim software will delete your setting again!

[SDK]
EnableDataBroadcast=1